|
Decorate
your table with a border of flags and make these simple red, white and
blue paperplate holders.
SUPPLIES
Red, white and blue spray paint
Wicker paperplate holders
Red, white and blue striped ribbon
White paper - 5.25" x 4"
Glue
Flag and Stars WALLIES® Cutouts - Determine how many will
be needed to make a border on all 4 sides of the table with about
1" space between each cutout. Cutouts are 5.25" long.
12114 Flag and Stars
|
 |
Instructions for Table Border
Before adhering the Cutouts,
place Flag Cutouts around the edge of the table, positioning them
about 1.5" from the edge and spacing the Flags about 1"
apart. When satisfied with placement, moisten Cutouts with wet
sponge and press into place by rubbing with dry paper towel. What
could be easier!
Instructions for Plate Holders:
Spray paint wicker paperplate
holders in red, white and blue paint. When dry, stack the plate
holders in any configuration that you like. Mount one Flag Cutout
on the piece of white paper and place on top of the stack.
Lay ribbon over the top of
the stack with half the length draped on either side. Holding
ribbon in place, flip stack over and tightly twist the ribbon
in the center of the stack on the bottom. Flip stack back to the
top and bring the ribbon up the sides in the opposite direction
of the first wrap. Tie a bow in the center and trim the ends of
the ribbon at an angle.
Now, give your guests some
time to admire your creation by making them wait awhile before
bringing out the food!
Back To PROJECT INDEX
|